Gas Geyser Installation
Kurts Gas Installers supplies, fits and commissions gas geysers across the East Rand and Gauteng. Over 15 years and more than 1,000 installations later, every geyser we fit is pressure tested, leak tested and issued with a Certificate of Compliance. Call 083 592 5450 for a free quote.
Need a gas geyser installed or replaced?
What a Gas Geyser Installation Includes
We supply and fit the geyser, run the gas pipework, and install the regulator, the flex connector, the shut-off valves and the fittings. Before we leave we pressure test and leak test the line, commission the geyser, check the flame and the hot-water flow, and write the Certificate of Compliance while we are still on site.
What is not included
We do the gas installation, not the plumbing - your plumber makes the final water connections. Every appliance we fit is on the LPGSA Safe Appliance List, which is how we meet SANS 1539. The geyser and the gas bottle are quoted separately from the installation price.
15
Years Experience
1000+
Gas Installations Completed
How we size a gas geyser
Gas geysers are rated in litres per minute at a 25 degree rise in water temperature. A 16 litre per minute unit is the minimum we recommend for a shower. A 6 litre per minute unit is fine for a basin or a kitchen sink. If two or three bathrooms draw hot water at the same time, go to 26 litres per minute.
Do not size the geyser to your home's flow rate alone. In winter the incoming water is colder, so the same unit delivers less hot water. A unit one size bigger has the capacity to take up the slack - and a bigger geyser does not use more gas by itself; it can simply heat more water when you ask it to. Our guide to what size gas geyser you need works through the numbers.
Fan-forced or natural draft?
A fan-forced geyser uses 220 V for its fan and electronics, but only about 80 W, so a small UPS or generator will keep it running during load-shedding. It holds a set temperature and uses gas only to reach that temperature, which is why we usually recommend one.
A natural draft geyser usually needs two D-cell batteries. It costs less up front, but it can cut out when another tap changes the pressure, and it needs adjusting through the seasons. If you are weighing the two, read which gas geyser is best for a bathroom and do gas geysers need electricity.
Gas geyser brands we install
We recommend Rinnai, Bosch and Paloma. Rinnai is the one we would choose on a slightly higher budget. Bosch has the Optiflow range and the 16 litre unit that the other two do not make, which makes it the obvious choice for a single shower. Paloma is competitively priced. For a tighter budget, the Dewhot 16 litre constant-temperature unit is a sensible option.
Whatever the brand, the unit has to be on the LPGSA Safe Appliance List. We will not fit an uncertified import, however good the price looks. Our guide to which gas geyser brand is best explains the trade-offs.
What happens on installation day
We check the appliance and the route, agree the price, and isolate the gas supply. We mount the geyser, run the pipework, fit the regulator and the flex connector, and pressure test and leak test the line. Then we commission it: light it, check the flame, set the temperature and check the hot-water flow at the tap.
We commission the geyser and issue the Certificate of Compliance before your plumber makes the final water connection, so the unit is proven to work before the water side is closed up. Every installation carries a 1-year workmanship warranty. If something we installed fails inside that year and it is our work, we come back and put it right.
Certificate of Compliance (CoC)
A Certificate of Compliance is the legal document that says your gas installation is safe and legal. Only a registered gas installer can issue one. You need it when you sell a property, when a landlord or agent asks for it, and if you ever have to claim on your insurance after a fire - without it, an insurer can decline the claim.
Every new or modified installation we do is issued with a CoC. If somebody else installed your gas and it is compliant, we can issue one after a leak test for R1500, which covers the callout, the test and the certificate.
Running costs and load-shedding
A gas geyser heats water as it flows, so there is no tank standing hot all day. What you pay depends on how much hot water you use, the temperature of the incoming water and the unit's gas consumption. Our gas geyser consumption calculator works out the monthly cost for a specific unit and household.
During load-shedding, a natural draft geyser runs on two D cells and a fan-forced geyser needs about 80 W, which a small UPS or generator can supply. Either way, you still have hot water when the grid is down. If you are also weighing gas against solar, read gas geyser or solar geyser and how much gas a gas geyser uses.
Installation prices
These are our current installation prices. The callout fee is included. The geyser and the gas bottle are not included, and the plumbing is separate - our own cost guide puts a plumber at around R2000 for a typical connection.
Outside installations are charged per metre of piping. A bottle five metres from the geyser therefore comes to R3050 plus 5 x R150, which is R3800. If you send us pictures of the job, we will give you an estimate over WhatsApp before we come out.
| Installation | Price |
|---|---|
| Outside installation - single connection | R3050 + R150 per metre of piping |
| Two connections with a change-over | R4050 + R150 per metre of piping |
| 20 m+ installation with 2nd stage regulator | R4350 + R150 per metre of piping |
| 20 m+ installation with 2nd stage regulator, 2 cylinders | R4650 + R150 per metre of piping |
| Certificate of Compliance only - callout, leak test and CoC | R1500 |
The Certificate of Compliance is included in every installation price above. A CoC on its own, for an installation somebody else did, is R1500 including the callout and the leak test - and only if that installation is compliant. The geyser and the gas bottle are quoted separately.
Our work
The photographs below are from our own jobs: Paloma and Rinnai geysers we installed, and the gas supply and reticulation that feed them. We have fitted well over 1,000 gas appliances over 15 years, and we would rather show you the work than somebody else's kitchen.
Areas we cover
We install gas geysers across the East Rand and Gauteng from our base in Elspark, Germiston. That includes Boksburg, Brakpan, Kempton Park, Bedfordview, Edenvale, Parkrand, Sunward Park, Brackenhurst, Randhart, Randburg and Johannesburg.
The same service has a page of its own: gas installers in Boksburg, Brakpan, Kempton Park, Bedfordview, Parkrand and Johannesburg. We also have geyser pages for Springs and Benoni. If you are outside these areas, call us and we will tell you straight away whether we can take the job on.
Why choose Kurts Gas Installers for your geyser
Experienced
Over 15 years and more than 1,000 gas installations behind us, from a single basin to a home with two or three bathrooms.
Certified
Every installation is pressure tested, leak tested and issued with a Certificate of Compliance. Every unit we fit is on the LPGSA Safe Appliance List, so it meets SANS 1539.
Priced up front
You get a written or verbal quote before we start, and we agree on the price and the payment method before we commence with the work.
Local
We work out of Elspark in Germiston and cover the East Rand and Gauteng. Monday to Friday, 8am to 5pm, with a 1-year workmanship warranty on every installation.
Frequently asked questions about gas geyser installation
How much does an outside installation cost?
How much does a CoC only cost?
Do we do electrical work?
What size gas geyser do I need for a family of four?
How long does a gas geyser take to heat up?
Do gas geysers need electricity?
Do you do the plumbing?
What warranty do you give on a gas geyser installation?
Installations, where the gas bottle is placed outside, are R3050 for a single connection and R150 per meter of piping.
Installations with 2 conections and a change over are R4050 and R150 per meter of piping.
We charge R1500 for the issuing of a CoC (depending on location) this includes callout, CoC and leak test. please note that this only applies to compliant installations that were installed by a regestred gas installer.
No, unfortunately, we do not, simply because we are not registered electricians, therefore, working on your homes electrical system would be ilegal and dangerous.
A 16 litre per minute geyser is the minimum we recommend for a shower, and it is enough for a family of four when one shower or tap runs at a time. If two or three bathrooms draw hot water together, go to 26 litres per minute. Size up rather than down, because winter incoming water is colder and the same unit then delivers less hot water.
About 6 to 10 seconds from the moment you open the hot tap. The heat exchanger starts at ambient temperature and the burner takes a few seconds to ignite. Fan-forced units tend to light slightly quicker than natural draft units.
Some do. Natural draft geysers usually run on two D-cell batteries. Fan-forced geysers use 220 V for the fan and electronics, but only about 80 W, so a small UPS or generator will keep one running during load-shedding.
No. We do the gas installation, commission the geyser and issue the Certificate of Compliance. Your plumber makes the water connections. We commission the geyser and issue the CoC before the plumber's final connection, so the unit is proven to work first.
Every installation carries a 1-year workmanship warranty. If something we installed fails inside that year and it is our work, we come back and put it right. A replaced part after a repair carries a 1-month warranty.
Contact Us
Call Us
Whatsapp Us
Click To Whatsapp