Are gas fires expensive to run?

AD

Most gas fires/fireplaces are quite expensive to run due to open-plan homes, poor insulation and poor appliance choice. However when there is proper insulation in a closed (but adequately ventilated room) and the correct gas fire/fireplace for the job it can be less expensive to operate.

Some gas fires/fireplaces are very expensive to run

Some gas fires/fireplaces do a poor job of spreading the heat that they produce around the room. They do a good job of looking good and add a nice ambience but they only give heat in close proximity to the heater. Everywhere else is cold as ice and it takes a very long time for that heat to circulate and warm the room (if it does).

Another problem is room size. Many people love to build these huge open plan houses with living rooms that take up half the house. This is a disaster when it comes to heating and even cooling. Every square meter of that room needs to be heated by a comparatively small heater, it’s like pulling a caravan with a bicycle it might be possible but it’s very impractical, it makes gas fires/fireplaces very expensive to run.

Insulation is also a problem in many houses, If you do not have adequate insulation (mainly in your roof) where your gas fire/fireplace is then heat will escape to outside the room. It would be the same as trying to fill a bucket with a hole in it, you can keep pumping water into that bucket, it will never be filled. It’s the same with gas fires/fireplaces, if you have poor insulation, you will keep burning gas but it will keep escaping to areas where you don’t need the heat, effectively wasting gas, this can make running gas fires/fireplaces very expensive.

What are some solutions?

Plan before building

If you are in the planning phase, consider adding doors to your living room area so you can reduce the volume of air the gas fire/fireplace has to heat up. Note: you need to install permanent cross ventilation in the room of the heater so that exhaust gasses can escape and fresh air can enter the room (consult your installer).

Get better insulation

Consult your builder and get better insulation installed in your roof, perhaps even install double glassed glass windows, that way you can keep heat out during summer and more importantly keep heat in, in winter.

Get the right heater for the job

There are heaters from Rinnai and Paloma that make use of a fan that do an excellent job of circulating heat, and also makes it so that there is better combustion of the LPG which in turn makes the appliance much safer (no/much less carbon monoxide). The fan-assisted heaters are leagues ahead of the standard fireplaces (where you can see the flames), they have much better safety’s, your toddler or pet cannot burn themselves in via direct flame contact and in fact, the Rinnai and Paloma heaters are safe to touch. They also have more advanced oxygen depletion sensors which is actually the main safety you should look at. And they are able to warm the whole room up even though the unit is only in one space. Oh, and did I mention that you can pack them away in the summer and not have that space wasted 😏.

Note: stock goes very fast on those units so get them while you can and ideally in summer when the demand is low.

Conclusion

Many factors can make running a gas fire/fireplace very expensive but with the right planning, you can greatly optimize the heat produced by your heater. Fan driven heaters are much more efficient at heating and circulating that heat, so they are a no brainer if you just want the most efficient way to heat up a room with gas. If you want the ambience and the look of flames rather just burn your money directly – just kidding, but I would advise getting a wood fireplace unless you have the right room size and insulation.

AD
AD
Share this post:

Related Articles

All posts